Sway Bar Rate Calculator
The Problem
Let’s face it, most decisions made by the automakers are based on one factor – cost. Without a doubt, it’s less expensive to manufacture and install smaller anti-sway bars, or in some cases, leave them off completely!
Our stock suspension does an adequate job in most situations. Where you may run into a problem (no pun intended) is when you need to make a sudden lane change to avoid an accident or when you find that curve in the road is a little sharper than you thought. As you vehicle begins to turn, the body will ” roll” transferring weight to the outside wheels. This causes the front end to “plow”, or what is technically known as understeer. The result – your vehicle wants to keep going straight and you’re out of control!
The Solution
With the addition of a set of ADDCO anti-sway bars, body roll and understeer will be greatly reduced resulting in a safer, more balanced suspension.
ADDCO carries the world’s largest line of anti-sway bars to fit virtually any vehicle. We’ve been supplying suspension components for over 38 years, and we’re committed to making your vehicle the safest on the road.
Handling
Neutral Steer
The front and rear of the vehicle will drift an equal amount and you will end up close to the starting point (actually, you will end up a little further out since the front and rear are drifting the same).
Understeer
Front tire drift causes the vehicle to refuse to turn as sharply as the direction of the wheels are pointed. If the wheels and the throttle are held steady, the vehicle will make an ever widening circle.
Oversteer
Rear tire drift is greater than that of the front and the rear tends to “spin out”. The vehicle will end up closer to the center of the circle because the rear tire drift changes the direction inward.
Bigger is not Always Better
Even a small increase in bar diameter provides a major increase in anti-sway bar effectiveness. Play it safe and stick with ADDCO’s recommendations to achieve the level of handling you desire.
